Ally Craft 480 Bar Raider (February 2005)

Finding a decent-sized boat without spending too much is a primary concern for anyone after a new entry-level runabout. Ally Craft's 480 Bar Raider delivers just that, and with a little more polishing it could be a real diamond

Buying affordable entry-level boats is no different to buying something much more upmarket. The only difference is the size of the rig - and the size of the hole in your bank account. You still need to buy into a boat that's going to serve your purpose as well as possible.

If you're looking for an affordable general-purpose aluminium boat, a good one to start with is the 480 Bar Raider from Ally Craft. It's a handy little family runabout with plenty of potential.

Open forward-control alloy runabouts under five metres still make up the lion's share of the trailerboat market, and for good reason: they're affordable and can comfortably take mum and a couple of kids out for a morning of fishing, skiing or a picnic on a secret beach somewhere. They're easily stored, cleaned, maintained and handled by relatively inexperienced boaters, and there's always demand for them on the second-hand market.

I say this boat shows potential because the particular craft we tested would have benefited greatly from a little more attention to detail, as well as a more careful fit-up. That said, a new 4.8m boat with a 60hp four-stroke on a walkaround trailer with a few options like a canopy and GPS/sounder for about $22,000 represents a lot of boat for your money.

DESIGN LINES
The helm on the 480 is positioned well forward, leaving plenty of room in the cockpit for setting up a couple of camp chairs for fishing back over the stern in comfort. Or you could drop one of those fibreglass iceboxes into the middle of the cockpit and sit on that.

The disadvantage of having the helm so far forward is that the floor in front of the driver and passenger seats slopes up from the keel to the chines in the bow. This did not present a problem when seated to drive, but on many occasions you want to stand up to drive, and an angled floor can make this uncomfortable.

The neat dash comprised a fibreglass module with two brows: one in front of the skipper holding engine instrumentation and an Eagle Cuda 240 GPS/sonar combo; and the other in front of the passenger, where a radio could be fitted. Not all tinnies of this size have fibreglass dash inserts, and it was a nice inclusion.

A deep rebate in the middle of the dash gives access to the short foredeck with anchor well and bowroller once you open out the centre section of the windscreen. This felt like a safe place to be in rough water, and it wasn't much of a reach to the anchor thanks to the cut-out in the dash.

Other handy features installed include a light-duty rocket launcher, two additional plastic rodholders in the gunwales, a sturdy baitboard with another two rodholders and a full-width outboard pod to maximise cockpit space.

PERFORMANCE & HANDLING
Keeping the overall package cost down in an entry-level boat like this is important if it's going to compete, but there's still some equipment on boats that shouldn't be compromised.

Being able to steer a boat comfortably is critical, and nothing spoils an otherwise great-handling rig like a below-par steering system. A few more hundred bucks for a hydraulic steering system really makes all the difference.

This boat had a mechanical system fitted, which is normal for a boat of this size, but it had an incessant loud squeak that would drive you nuts after a while. It sounded like plastic on plastic, so it could have been the base of the wheel against the mount section. In any case, the torque generated by the 60hp Mercury four-stroke appeared too much for the system to handle, and steering was uncomfortable.

When releasing a new model, it can take a bit of fiddling to get the engine mounted correctly on the transom - and to find the right prop for the hull and motor combination. The test boat's engine needed to be dropped down another bolthole on the transom, and perhaps have a different propeller installed.

We'd be keen to revisit this boat once these glitches have been ironed out, because as presented, its performance was somewhat disappointing.

Trimmed right in, the engine got the boat planing without fuss. But the propeller cavitated both in a straight line and during turns once the motor was trimmed out for a more efficient plane. Because of the negative trim needed to stop the cavitation, the bow ploughed into the chop and we couldn't evaluate the ride and handling when the boat was correctly trimmed.

Top speed at 5600rpm was just on 50kmh.

ROOM TO IMPROVE
The remote-control box installation also needed attention, as when pulling back to neutral a "notch" was found, allowing the gears in the out leg to remain slightly touching.

The actual neutral position was further aft on the control and its general performance was unacceptably stiff. Again, this problem is easily fixed at installation time.

I found the finish on the hull needed improvement. Handrails that had been docked with a saw still had burrs, and plastic end caps for tubing wouldn't go astray either. It would add but a few cents to the final price, but it would go a long way towards making the rig smarter.

While it sounds like we've had a real bitch here, in reality these are only slight problems concerning outboard installation and control-box setup, which needs to be spot-on to make the hull perform. The only real design aspect to mar an otherwise practical little river and bay runabout is the deck angle at the helm seat. Perhaps it won't bother most buyers, but I like to stand and drive when navigating over shallow or choppy water. If these issues are addressed, we see no reason why this boat wouldn't make a top value-for-money package: the hull is strong, and the four-stroke was quiet and economical. Most importantly, the boat was stable and had nice high sides for security. Just add water!

HIGHS

Plenty of cockpit space for a boat of this length
Good stability
Plenty of boat for the money

LOWS

Excessive engine cavitation on test boat
Remote box overly stiff
Deck angle at helm makes stand-up driving uncomfortable
Some aspects of the finish need attention

ALLY CRAFT BAR RAIDER 480

Price as tested: $22,900

Options fitted

Four-stroke outboard, canopy, clears, sounder/GPS, bilge pump, compass, deluxe walkaround trailer

Priced from: approx $21,000 w/ Mercury 60hp four-stroke

GENERAL

Material: Aluminium

Length (overall): 4.9m

Beam: 2.25m

Deadrise: 18º

Weight: 320kg (hull only)

CAPACITIES

Rec/max hp: 60/80

Fuel: 65lt underfloor

Passengers: Five adults

ENGINE

Make/model: Mercury F60

Type: Four-cylinder four-stroke

Rated hp: 60

Displacement: 995cc

Weight: 112kg

Gearbox ratio: 1.83:1

Propeller: 13in aluminium

SUPPLIED BY Cunningham Marine, 279–287 Oxley Ave, Redcliffe, Qld, tel (07) 3284 2342, email info@cunninghamsmarine.com.au or visit www.cunninghamsmarine.com.au

Published : Tuesday, 1 February 2005
Issue : February 2005

---

disclaimer

Prices and specifications supplied are for the market in Australia only and were correct at time of first publication. BoatPoint Australia makes no warranty as to the accuracy of specifications or prices. Please check with manufacturer or local dealer for current pricing and specifications.